Thanx for coming here
Hi-fi robot
Thanx for coming here
You might get disappointed with the robot
Introducing the hi-fi robot
//////////photo of high fi robot//////
Requirements :
- cardboard sheet
- Arduino
- Jumper wires
- Ultrasonic sensor
- Paper tape
- Scissor
- Servo motor
Inscape file for laser cutting :
Process:
- First load the file in inscape convert the file from SVG to DXF file in inscape
- Then load the DXF file into the RDWorks software
- Cut the given file in laser cutter
- Then add the ultrasonic sensor it the holes provided
- Then do the Arduino connections as shown in the diagram
- /////// photo of the ultrasonic =sensor
- The vcc and gnd pins provide power to the ultrasonic sensor
- The trigger and the echo pins provide the input and output data respectively
- The yellow wire of the servo is the signal pin getting the signal data
- //// photo of the servo
- Do the connections as shown in the picture
- Connect the Arduino with the Arduino cable to the computer
- Code:
- ///// write the code here
- Upload he code
- Now when you take your hand in the proximity to the ultrasonic sensor the had=nd would come up to give you the hi-fi
