Installation CCTV camera:-
1.Hardware:- CCTV camers (Bullet or Dome), DVR Or NVR recorder, and a Surveillance Hard Disk Drive (HDD).
2. cabling:- Siamese Coaxial cable RG59 with power wires) for analog or Cat 6 Ethernet Cable for IP/POR system.
3.Connectors:- BNC male Connectors (for video) and De power plugs / Jacks, or RJUS plugs for network lines.
4.power:-12V DC power supply unit (SMPS) or individual power adapter.
How to fix and mount the camera:-
1.pick a spot:- place cameras 8 to 10 feet high near entry points to avoid blind spots and physical tampering
2.Mark and drill:- Hold the camera bracket aganist the calt mart screw holes with a pencil, drill the holes, and push in plastic wall anchors (raw plugs).
3.Secure the mount: Drive Screws through the bracker hores into the anchors to look the camera base tightly to the wall. Adjust the lens angle and tighten the position lock knob.
How to connect the wiring!-
1.Run the cable!- Lay the cable from each camera location back to where you keep your OvR recorder.
2.Attach video Connection!- strip the Coaxial cable endse attach the BNC connetors plug one end into the camera video output and the other into a video input Channel to DUR.
3.Hook up power:- Separate the power lines from video cable, attach the Dc power & Connect them to your rzv power supply Link the recorder:- put your hard drive inside the DVR, plug the DR into a display Screen using on HOMI or vga cable and power on.
