AIM: make a box and final out of iron sheet
requirement : iron sheet , cutter , Marker Pen ruler hammer spot welder plier
Procedure: 1) the design adjoining to this page on the iron sheet with proper measurement
2) hold the box at mark places
3) then take the bottom portion of the box and do the same with it
4) Fix the bottom of the box onto the body and memory drown
5) do the same lid but it should be bigger than the dimension of the box Bird
6) Complete the finishing with the hammer
requirements for funnel : iron sheet, cutter ,marker ,ruler, spot welder ,plier
procedure : 1)do the marking as shown in the adjoining figure
2)folder design on the Marked places
3)to the same with the bottom part of the funnel
4)spot weld on the market places
5)fix the pipe part of the funnel
